How to assemble the accessories
Concentrating nozzle B1, extension hose B2
Can be put on the steam nozzle
A6
by simple sliding it down completely, and securing in
place (Fig. 2). Apply reverse procedure to remove. First you have to press the security lock
lever on the respective adapter.
Accessories B3-B8
The accessories can be mounted on the concentrating nozzle
B1
, or the extension hose
B2
by sliding it down completely and rotating it clockwise until fixed (see the detail in Fig. 2).
Apply reverse procedure to remove. When removing the adapter
B8a
and the squeegee
B8c
from the nozzle for windows and flat surfaces
B8
, first you have to release the security lock,
and then remove the component by pulling it away.
Attention
Before using the appliance, check all the components if they are properly connected
and assembled! Make sure that the contact surfaces and sealing elements are clean
and undamaged.
Water filling
When filling water, make sure that the appliance is disconnected from the mains. Remove the
container
A4
from the steam unit A by rotating it anti-clockwise (see detail in Fig. 2), and pulling
it out. If the water filter
A5
must be replaced, pull it out from the steam cleaner body. Remove
the water tank plug
A8
from the tank by rotating it (see the detail in Fig. 2) in OPEN direction.
Fill the tank with water. Do not exceed the maximum permitted volume of water (i.e. 275
ml). Put the plug in place by rotating it in CLOSE direction. Install the assembled tank on the
steam unit
A
by putting it on and rotating clockwise.
Filling water/detergent in the mopping nozzle
First open the tank lid
D2
and pour water/detergent inside. You can use the water replenishing
container
F
– however if you use a detergent, and then you are going to use the container
F
for replenishing water to the water tank
A4
, first rinse the container thoroughly!
The maximum container volume is about 150 ml. Close the lid after replenishing water.
Attention
– Never use the appliance without the water filter
A5
properly fixed.
– Before replenishing the mopping nozzle tank
D
, disconnect the appliance from the mains
and let the mopping nozzle
D
cool down.
– The steel ball of water tank plug
A8
at the end of the hose must permanently
and freely move below the water level. If it gets stuck, free it by shaking the cleaner.
– When using a detergent, follow the safety warnings and dosing instructions provided
on the detergent packaging! Use an adequate quantity of the detergent solution.
Floor coverings (for example carpet) must not become completely soaked.
IV. STEAM CLEANER USE
First choose the appliance assembly variant, and then add/remove the respective
components and accessories of the appliance as needed. Unwind the power cord
A9
from
the extension adapter holder
C
, and plug the power cord in a wall socket. Switch on the
appliance by pressing
ON/OFF
, which will be indicated by turning on the operation light
indicator
A2
.
26
GB
/ 47
