eta 0270 90000, Инструкция по эксплуатации

Страница: 23 / 48

D – Filling cup
Control panel ( A2 )
This is a touch control panel. Therefore, no pressure needs to be applied to touch the
symbols displayed.
The symbol = the appliance is on / is off.
The symbol
ECO
= softly steaming.
The symbol = intensive steaming.
III. INSTRUCTIONS FOR USE
Remove all packaging materials and take out the appliance and the accessories. Remove
all adhesive foils, stickers and papers. This appliance is designed to be used in a vertical
position, with hanging garments (garments must be in an upright position - e.g. hanging on
a hanger). Do not use the appliance on an ironing board or horizontal surfaces and do not
hold it upside down - this causes inconsistent steam. To achieve the best results, always
hold the appliance in an upright (i.e. vertical) position when in use.
Filling up the tank with water
(
B
)
Pull the water tank B out and take off the cover of the water funnel B1 . Pour clean in water
to the container
B
with the enclosed cup
D
up to the line (max 250 ml.) and close the filling
hole lid in the opposite direction. Insert the tank into the boiler in a reverse way, end-to-end,
which is accompanied by characteristic sound (clicking).
At pla ces with hard water we recommend diluting it with distilled water. You will get the
information about water hardness at the water-management authorities, or at the local sanitary
station. For water hardness > 15 °N we recommend filling the appliance in the following ratio:
Water hardness Ratio of tap water : distilled water
medium 2 : 1
hard 1 : 1
very hard 1 : 2
Removing / attaching the brush ( C )
Insert the brush through the projection created into the opening in the upper part of the
garment steamer and attach it applying a slight pressure (you will hear a click). To remove
the brush, hold the projection created and remove the brush, pulling it slightly.
Attention
– When using the appliance, you will hear an inherent noise sound and vibration. This is
normal and the appliance will not be replaced for this purpose under warranty.
– Do not use your bare hand as a supporting surface when you steam.
IV. GARMENT STEAMER USE (Fig. 2)
The appliance becomes active and starts heating the water in the tank once you connect
it to the mains. Connect the power supply plug A5 to the mains. When you press the
button on the control panel A2 for approx. 2 seconds, the appliance will switch on and water
heating will be activated which is indicated by the red indicator coming on and the blue
indicator flashing.
GB
23 / 42