The app menu <Settings>
Doc. no. BA012497_02
95 / 107
GB
Activating light measurement using the DALI presence detector:
Prerequisites:
•
The universal remote control displays "X-Light Control" in the first
display line.
If it does not: Set the universal remote control to the remote control
X-Light Control. To do this, follow the steps in Chapter “Selecting
X-Light Control remote control” page
• Choose a position as close as possible to being directly underneath
the master light that you want to configure.
• Aim the remote control directly at the detector so that only this light
receives the remote control signal.
Switch on the remote control using the
button.
Select the <Programming> menu item and confirm the selection with
the
button.
Enable programming mode by pressing the
button.
Select the
button to choose the menu item <Light value on> and
confirm the selection with the
button.
The red LED flashes three times in the sensor head.
End programming mode by pressing the
button.
Light measurement is activated.
To avoid conflicting controls, only one DALI detector per room
should ever perform light measurement.
Setting the light target value:
Start configuration of the light target value in the app by tapping on
<Configure now>. under
Manual settings.
The settings menu is displayed:
Only for lights
without light
sensor