
The remote control menu <Programming>
Doc. no. BA012497_02
63 / 107
GB
the
button.
4.
Change the luminous efficiency value to 60 % using the
button.
Confirm your selection with the
button.
5. Press the
button once.
6. To change the switch status of DALI switch 1 or 2, use the
button
to navigate to the matrix point DSw1 or DSw2 and confirm the selec
-
tion with the
button.
7. Use the
or
buttons to set the required switching status and
confirm the selection with the
button.
8. Press the
button once.
You are now in the matrix again at the previous position. The set
values must now be transmitted to the Light Control Box:
9. Use the
button to navigate to the line <Scene>.
The matrix point <OK> is highlighted.
10. Press the
button once.
<Send scene…> appears in the display. The remote control sends
the new values to the Light Control Box.
The scene editor saves the last set values. Therefore, if you want
to set the same scene in a different room, simply enter program-
ming mode, and send the required scene to the Light Control Box
by clicking on <OK>.
8.8 Calendar
In the <Calendar> menu, you can enter the date and time. It is important to
set the time if you want the orientation light to start and end at fixed times.
The time should be checked once a year.
Thanks to the built-in battery, the settings are also retained in the
event of a power failure.
Setting the date:
1.
Select the <Programming> menu item and confirm the selection with
the
button.
2. Enable programming mode by pressing the
button.