Estun E200P, Руководство по эксплуатации

Страница: 12 / 25

E200P Operation Manual
10
Chapter 3 Operation Description
3.1 Basic Operation
3.1.1 Start and Stop
 After finishing the programming, press to run the machine.
 The device starts, the green indicator light.
 Only on the SINGLE page, PROAGRAM page or STEP page, the machine can run
after pressing . In other pages, press to run is invalid.
 When there is any alarm, the machine cannot start until the alarm is clear, the
machine can start again.
 Press to stop the machine immediately, at the same time, the page on the
device backs to the previous programming page.
 The device does not start, the red indicator light.
3.1.2 Parameter Setting
 When editing the parameter, press to select the parameter you
want to modify, input the value and press to finish.
 When editing the parameter, please accord to the tip on the page to edit. If the
value out of range, the page will display Out of range , please input a correct value
again.
3.1.3 Alarm Reset
 When there is any alarm, the machine stops immediately. If you want to recover the
machine’s operation, you need to clear the alarm.
 On the CONST page, press to enter the ALARM RECORD page, the most of
top is the recent alarm information. Please according to the information on the page
to processing the problem, and then press and to clear the alarm,
finally you can run the machine.
3.1.4 Monitor
 On the CONST page, press to enter IO MONITOR page.
 ON the IO MONITOR page, press to enter YV MONITOR page.