ESTechnical Reflow Oven Controller Full Upgrade Kit for T962A
45 of 50
Operating Instructions
Starting a reflow cycle
Navigate to
Cycle start
in the menu and press
OK
. The controller will perform the cycle using the
current cycle settings.
Stopping a cycle
Should you need to abort a reflow cycle, press the
S
key. The oven will move into the
Cool down
state. Observe the temperature on the display before attempting to open the drawer or remove
boards.
Saving an edited profile
To save a profile navigate to
Save Profile
and press
OK
. Choose a profile number to save (by
default all 30 profiles are the same, the user can save to any of these profiles) and then press
OK
. The
profile is now saved in the chosen profile number.
Please note that any previous settings in the profile number you save to will be overwritten with the
new settings.
Loading a saved reflow profile
Navigate to
Load Profile
and press
OK
, using the
<
and
>
keys, choose the profile number you
wish to load. Press
OK
, the reflow profile settings will be loaded. When running a reflow cycle, these
settings will now be used.
Editing the active profile
Navigate to
Edit profile
and press
OK
, then navigate to the parameter you wish to edit. The
options are
Ramp up rate
,
Soak temperature
,
Soak duration
,
Peak temperature
,
Peak
duration
and
Ramp down rate
. Press
OK
once you have selected the option to edit, the controller
will display the value and allow editing using the
<
and
>
keys. Press
OK
to confirm your changes, or
to cancel press
Back
. Repeat these steps to edit each parameter you wish to adjust.
When running a reflow cycle, the controller will use the settings as per your adjustment.
N.B. This process edits the variables stored in RAM and does not save
the changes permanently until you save the profile.
Fan Idle Speed Adjustment Procedure
