9
7. With the gate in the
OPEN
position, at-
tach the gate opener to the post bracket
assembly and gate bracket. Swing the arm
over to the gate and mark the holes. For the
gate bracket.
NEVER
tur n the shaft of the gate open-
er, it is located in the correct open retracted
position from factory.
7. With the gate in the
CLOSED
position,
attach the gate opener to the post bracket
assembly and gate bracket. Swing the arm
over to the gate and mark the holes. For
the gate bracket.
NEVER
tur n the shaft of the gate open-
er, it is located in the correct closed re-
tracted position from factory.
8. Prior to drilling the holes for your gate
bracket, place a level on the shaft of the
gate opener to check levelness.
Drill the two oblong holes with a 3/8” drill
bit and secure using 3/8” carriage bolts,
lock washers, washers and nuts. Recheck
the open position, at this point it is adjusta-
ble by the length of the oblong holes. After
the location is confirmed drill a 1/4” hole
through the center hole of the gate bracket
to lock its horizontal position.
Secure with a 1/4” hex bolt, lock washer,
washer, and nut.
9. Secure the arm in place with a cotter pin
on the gate side and a C clip on the post
side.
9. Secure the arm in place with a cotter
pin on the gate side and a C clip on the
post side.
8. Prior to drilling the holes for your gate
bracket, place a level on the shaft of the
gate opener to check levelness.
Drill the two oblong holes with a 3/8”
drill bit and secure using 3/8” carriage
bolts, lock washers, washers and nuts.
Recheck the open position, at this point it
is adjustable by the length of the oblong
holes. After the location is confirmed
drill a 1/4” hole through the center hole
of the gate bracket to lock its horizontal
position.
Secure with a 1/4” hex bolt, lock washer,
washer, and nut.