74020-52-00
DUSTOMAT-160 S
15
5.
Transport and installation
5.1 Transport
DANGER
Risk of falling and tripping
Danger to life from falling objects or loads
•
Do not stand under suspended loads.
•
Secure the assembly area and mark it out (e.g., with barrier tape).
•
Always lift the product vertically during loading and assembly work.
•
Only transport the product with suitable, approved means of lifting and
transport.
•
Do not place the product on a sloping surface.
•
Wear personal protective equipment
.
•
Observe the local accident prevention regulations.
WARNING
Crushing hazard when setting the product down
Injuries to the hands and feet
•
Secure the product against tipping and falling during transport.
•
Set the product down carefully and cautiously during set-up.
•
Wear work gloves and safety shoes.
NOTE
Material damage due to improper transport
Damage to the housing, lines and product components
•
Do not push or pull the product across the floor if it does not have any rollers.
•
Seal the intake port with a sealing plug so it is dust-tight during transportation.
•
Pay attention to any protruding components when setting down the product.
•
Note the centre of gravity (which is not in the centre) when setting down the prod-
uct.
•
Make sure that the surface can be driven on, is level and sufficiently load bearing.
The product is delivered fastened to a pallet. Following removal of the protective covers
and the floor fixing, the device can be lifted using a forklift truck.
Do not
use a crane.
1. Remove the packaging and check the product for damage and completeness
2. The product must not be put into operation if there is damage, or if the delivery is in-
complete. Contact ESTA in such cases
3. Any foreign objects inside the product must be removed before start-up.
