Essilor Mr Blue 2.0, Руководство пользователя

Страница: 28 / 152

USER MANUAL > TRACING
28 Mr Blue 2.0 > v4.0 -09.16
7
6
5
4
3
2
1
7
In the case of a groove located at the back of the frame, select a high insertion .
In the case of a groove located in the front of the frame, select a low insertion .
Press on to start the tracing cycle.
To interrupt tracing at any time, press .
Tracing - tracing mode
In tracing - tracing mode, the result of the tracing is displayed in the work area of the tracing screen. For more information on
working modes, consult the section
. Perform a trace > Tracing environment > Jobs and working modes (p.21)
Before Centering
If you want to modify the shape of the lenses, consult the chapter Modify the lens shape. (p.83)
If you want to add drilling points to your lenses, refer to the section Preparing a drilled job.
4. Tracing a high-base frame
This specific procedure enables you to trace a high-base frame, if the standard rimmed frame tracing fails.
Tracing of a high-base frame is done in two stages:
The frame is placed in the tracing table and mechanical tracing is done for each eye individually.
The curve angle is measured and the tracing is completed.
Put the frame in place and start the tracing
When you place the frame in the tracing table, position the eye as flat as possible: the black clamps which hold the eye to be
traced must be in the middle of the circle.
Gently close the jaw to hold the frame.
Press to select the high-base frame type.
Press to select the first eye to be traced.
Select the frame material.
Select the type of groove insertion, medium, high or low.
Press on to start the tracing cycle.
If you selected a monocular tracing, the numeric keypad is displayed. Enter the value of the D-dimension, then press
to confirm.
>
The tracing result is displayed in the centering screen, in monocular format on a 1:1.6 scale. >