background image

PIR Coach Lantern

5543J

27/08/2015

For your safety, always switch off the supply before changing lightbulbs, or cleaning.

Recycling advice

Safety information

Do not use solvents or abrasive cleaners as these could damage the finish.
Glass -  Remove and wash in warm water or just use a damp cloth. Do not use abrasive materials.
Do not clean the units with a pressure washer.

This bulb is protected by a shade. This part must be replaced immediately should the shade 
become cracked or damaged. This fitting must not be used without the shade in place.

Care and cleaning

Waste electrical products should not be disposed of with household waste. Please recycle where facilities 
exist. Check with your Local Authority or retailer for recycling advice.

Fitting/replacing bulbs

When changing a bulb, always switch off at the mains and allow the bulb to cool before handling. 
Dispose of used bulbs carefully.
Do not exceed the wattage stated from that indicated on the fitting.
To access the bulb, remove the decorative nuts on top of the shade, and lift off the top. Set aside.
Relocate the shade top over the screws and secure in place with the screws.

Replace Cracked

Shade

Please note this product is fitted with 
a daylight sensor, therefore it will only 
activate once the ambient light level 
drops below 10 Lux.

Duration the bulb stays on is

adjustable by turning ‘Time’ screw

Detection range can be adjusted

by turning ‘Sens’ screw

Base of product

Adjustable 6 - 12 metres

TIME

SENS

3m

6m

8m

12m

120˚

Отзывы: