ESPEC Platinous ESL Series, Руководство пользователя

Страница: 63 / 125

Platinous User’s Manual
57
Operation
FIGURE 6.35.
H
OW TO FEED SPECIMEN CABLES THROUGH THE CABLE PORT
Use a specimen cable that can withstand test conditions. Refer to the following table for possible cable
types.
TABLE 6.12.
C
ABLE TYPE AND WITHSTAND TEMPERATURE
When not using the cable port, fit a silicone rubber plug in it from the inside and outside.
FIGURE 6.36.
W
HEN NOT USING CABLE PORTS
6.1.3 Wet-Bulb Wick Check (ESL, ESX models only)
The wet-bulb wick (included) must be installed to run humidity tests. If already in place, check whether it is
wet or dry before starting. If dry, change it.
Note:
Bacteria adhering to the wet-bulb wick can proliferate during tests and block water
supply. Wash hands with soap and water before handling the wick.
Procedure:
1. Remove the wet-bulb wick from its package.
2. Slide the wet-bulb wick over the wet-bulb temperature sensor. It is easier to slide the wick over the
sensor by folding it in half.
Specimen
Rubber plug
Specimen cable
To specimen power
supply control terminal
and power supply
Cable Type Withstand
Temperature
Vinyl Cable 55°C
Styrene-butadiene cabtyre cable 70°C
Electron crosslinked heat-proof plastic cable 100°C
Glass-braid silicon shielded cable 200°C
Rubber plugs