Installation
50
Platinous User’s Manual
2. Check that the water level in the humidifying tray water level regulator is at the water level for humidifier
mark. If adjustment is required, see “Reference” Step 2. below.
FIGURE 5.28.
W
ATER
LEVEL
CHECK
IN
HUMIDIFYING
TRAY
3. Close the water circuit compartment door.
Reference:
If water level is low or high, regulate it as follows:
1. Loosen the position adjusting screw and raise/lower the water level regulator.
2. If water level cannot be regulated in step 1, loosen the nut and turn the water level sen-
sor clockwise (seen from above) to lower water level, or counter-clockwise to raise it.
Then, re-tighten the nut.
3. Close the water circuit compartment door and set the main power breaker to ON.
4. When water supply is complete, press the OPER./START key or the chamber operating
status box to get the Operation Mode Selection screen again. Then press the STOP
button under Stop Operation followed by the YES button on the confirmation message.
The chamber will stop.
5. Press either the OPER./START key on the operating panel or the chamber operating
status box on the screen to get the Operation Mode Selection Screen. Then press the
START button under Constant Mode followed by the YES button on the confirmation
message. The chamber will start up and the tray will fill.
6. Check water is the proper level. If water level is ok, the chamber is ready for use. If not,
repeat steps 1-5.
5.7.6 To Check Water Level in the Wick Pan
Procedure:
1. The standard water level in the wick pan arm should be such that water does not overflow to the cham-
ber or is not extremely low.
2. The wick pan arm should be level.
¼
ins.
WATER LEVEL FOR
HUMIDIFIER Mark
Nut
Humidifying tray
Water Level Regulator
Humidifying
Tray
Water level sensor
Position adjusting
screw
Содержание Platinous ESL Series
