Hardware Installation
3. Hardware Installation
Read the safety instructions at the beginning of this document carefully,
before you start with the hardware installation!
Danger!
Electric shock risk. Never carry out work while power supply voltage is switched on!
Attention !
Electrostatic discharges may cause damage to electronic components. To avoid
this, please perform the following steps
before
you touch the CPCI-COM4, in order
to discharge the static electricity from your body:
Switch off the power of your computer, but leave it connected to the mains until
you have discharged yourself (if applicable).
Please touch the metal case of the computer now to discharge yourself.
Furthermore, you should prevent your clothes from touching the computer,
because your clothes might be electrostatically charged as well.
Procedure:
1.
Switch off your computer and all connected peripheral devices (monitor, printer, etc.).
2.
Discharge your body as described above.
3.
Disconnect the computer from the mains.
If the computer does not have a flexible mains cable, but is directly connected to mains,
disconnect the power supply via the safety fuse and make sure that the fuse cannot switch
on again unintentionally (i.e. with caution label).
Danger!
Never carry out work while power supply voltage is switched on!
4.
Open the case.
5.
Insert the CPCI-COM4 board into a free CompactPCI slot in your computer.
6.
Close the computer case again.
7.
Fix the CPCI-COM4 board with the screws on the front panel.
8.
Connect the serial interfaces (COM1- COM4) via the DSUB37 connector in the front panel of
the CPCI-COM4 (see page 7).
9.
Connect the computer to mains again (mains connector or safety fuse).
10. Switch on the computer and the peripheral devices.
11. End of hardware installation.
Page 8 of 17
Hardware Manual • Doc. No.: I.2328.21 / Rev. 1.0
CPCI-COM4
