Esaote MyLabX75VET, Начало работы

Страница: 127 / 138

M A I N T E N A N C E
MyLab
- G E T T I N G S T A R T E D 8 - 5
GETTI
NG STARTED
Clean the ball rotating it in its socket. Do not remove the ball from the socket.
WARNING
Do not remove the ball from the socket.
WARNING
Do not try to disassemble the trackball during the cleaning of the
removable sealing ring.
Cleaning Probe and Gel Holders
Probe and gel holders are easily removable from their location for cleaning
and can be washed in a mild soap solution. Make sure they are completely dry
before replacing them.
 PC
To clean the probes, refer to the manual “Probes and Consumables”.
NOTE
Sonogel and Scan MV gels, listed in Probes and Consumables manual as
compatible with Esaote probes, have not been tested on
MyLab
plastic
covers.
Cleaning the Touchscreen
To clean the touchscreen, switch
MyLab
off, unplug it and use a soft dry cloth,
lightly rubbing the display surface. To remove stains, lightly dampen the cloth
with ethanol and water mixed in a 1:1 ratio and gently wipe the touch panel
surface; afterwards, dry the touch panel with a new dry cloth.
If strictly necessary, to clean the touchscreen during an examination, you can
temporarily lock the keyboard and the touchscreen pressing
FREEZE
while
keeping
ETO UC H
pressed. When
MyLab
is on and connected to the mains, for
safety reason, you must use only a soft dry cloth to clean the touchscreen.
Do not spray or apply the cleaning agents directly on the touchscreen surface
as the liquid of the cleaning agents may permeate into the front bezel of the
display and cause damage.
Do not press the touchscreen with any sharp objects as this may damage the
screen.
When
MyLab
has not been unplugged, clean the touchscreen exclusively using
a dry cloth. Never use wet cloth.