Esaote MyLabX75VET, Начало работы

Страница: 126 / 138

M A I N T E N A N C E
MyLab
- G E T T I N G S T A R T E D 8 - 4
A visual inspection of the parts subjected to the cleaning process in order to
evaluate possible damages or deteriorations.
Cleaning control panel and device
To clean the control panel and device, switch the
MyLab
off, unplug it and use
a soft cloth slightly dampened with water.
If necessary use the suggested wipes, or a soft cloth slightly dampened with
one of the suggested cleaning agents.
Otherwise, apply a small amount of ammonia-free and not abrasive detergent
on a clean, soft cloth and then wipe the surface.
CAUTION
Make sure that the detergent has completely evaporated before turning the
equipment on.
CAUTION
Do not use any type of ammonia- or benzene-based cleaners on the case.
Cleaning the QWERTY keyboard
To clean the QWERTY keyboard switch your
MyLab
off, unplug it and use
commercial wet wipes only.
CAUTION
Do not use any kind of spray, foam, gel cleaner on the QWERTY keyboard,
either directly or on moistened soft cloths, which could lead to a drop
inside. This can cause damage to the QWERTY keyboard, which could
lead to system malfunctioning.
NOTE
The QWERTY keyboard can be protected with a latex-free plastic cover.
The life of the cover depends on how the QWERTY is used and how it is
cleaned. If the cover is broken or damaged contact Esaote Service or Sales
Representative to purchase a new one, then replace it according to the
instructions enclosed with the cover itself.
Cleaning the trackball
The trackball can be accessed, for cleaning purpose only, by rotating
counterclockwise the upper locking disk.
Once the disk has been removed, clean the trackball using a soft dry cloth.
Clean the trackball housing using a cotton swab.
CAUTION
When cleaning the trackball housing, make sure not to spray any liquid into
the trackball housing.