Esaote MyLabX6, Начало работы

Страница: 68 / 124

U S I N G T H E S Y S T E M
MyLab
- G E T T I N G S T A R T E D 5 - 2
6. Connect the network and other cables from the system to the
appropriate wall plugs.
7. Plug the cable to a reliable grounding power outlet to assure
adequate grounding.
8. Turn the main switch of the rear panel on.
9. Press
O N /O FF
to turn on the system.
WARNING
When installing
MyLab
, check that the power cable is not tightly bent, that
it can’t be squashed by a misplaced foot or by heavy objects.
WARNING
Position the system in a location allowing an easy unplug of
MyLab
from the
mains in case of need.
NOTE
It is recommended to turn the rear panel switch off before unplugging the
power cable, whenever the system is expected not to be used for long
periods.
NOTE
Whenever the system has to be insulated from the mains, disconnect the
cable from the power outlet.
CAUTION
Do not turn the system off while working (for example saving data) or
during the initialization phase: the hard disk could be damaged by this
operation.
CAUTION
This is a PC based system; data loss or driver damage may occur if the
system is turned off while working (for example saving data) or during the
initialization phase. Refer to the appropriate chapters of this manual for
detailed information on when and how to safely power the system off.
System Controls
System controls are located on the Control Panel Assembly that includes the
control panel, the touch screen and the alphanumeric keyboard.
Control Panel Section
The control panel includes the main imaging controls: the exam control
buttons and knobs, and the trackball. The control module also allows to select
imaging modes, review and annotate images, perform measurements and
calculations.