5 OPERATION
0459 087 687
- 16 -
© ESAB AB 2017
5.6
Remote control unit
When the remote control unit is connected, the power source and wire feed unit are in
remote control mode; the buttons and knobs are blocked. The functions can only be adjusted
via the remote unit.
If the remote control unit is not to be used, the remote control unit must be disconnected from
the power source / wire feed unit, as otherwise it will remain in remote control mode.
For more information about the operation of the remote control unit, see the operating
instructions for the control panel.
5.7
WeldCloud™ unit
The WeldCloud™ unit connects the welding power source with a local WeldCloud™ server
through Wi-Fi, Wired LAN or 3G. The WeldCloud™ unit is equipped with GPS to track the
location of the welding power source. It also has Bluetooth connectivity to enable connection
with 3
rd
party input devices, for example a Bluetooth enabled barcode/QR scanner.
The WeldCloud™ unit Wi-Fi is enabled at power up of the power source. It will start as a
hotspot that appears as an available Wi-Fi network. After establishing connection, it is
possible to access the web interface of the power source for a one-time set-up. After set-up
and restart, the power source will be visible in WeldCloud™. For more information about the
WeldCloud™ unit and features, see the WeldCloud™ instruction manual.
Содержание Aristo WeldCloud Mig U5000i
Страница 2: ......
Страница 3: ......
Страница 21: ...DIAGRAM 0459 087 687 21 ESAB AB 2017 DIAGRAM...