ESAB Aristo Mig 4001i, Инструкция по эксплуатации, Страница: 12 / 26

5 OPERATION
0460 740 001 - 12 - © ESAB AB 2017
5 OPERATION
General safety regulations for handling the equipment can be found in the "SAFETY"
chapter of this manual. Read it through before you start using the equipment!
5.1 Connections and control devices
1 Connection for wire feed unit or remote
control unit 4 Mains power supply switch, 0 / 1 /
START
2 Connection (-) MIG/MAG: Return cable
TIG: Welding torch
MMA: Return cable or welding cable
5 Fuse for operating voltage, 42 V
3 Connection (+) MIG/MAG: Welding
cable
TIG: Return cable
MMA: Welding cable or return cable
5.2 Connection of welding and return cable
The power source has two outputs, a positive terminal (+) and a negative terminal (-), for
connecting welding and return cables. The output to which the welding cable is connected
depends on the welding method or type of electrode used.
Connect the return cable to the other output on the power source. Secure the return cable's
contact clamp to the work piece and ensure that there is good contact between the work
piece and the output for the return cable on the power source.
For MMA welding, the welding cable can be connected to the positive terminal (+) or
negative terminal (-) depending on the type of electrode used. The connecting polarity is
stated on the electrode packaging.
5.3 Turning on the power source
Turn on the mains power by turning switch (4) to the ”START” position. Release the switch,
and it will return to the ”1” position.