ESAB 0700 200 015, Инструкция по эксплуатации

Страница: 12 / 20

© ESAB AB 2005
- 12 -
bg17e
Problem Solution Cause
Variable arc
S
Contact tip is worn or does not
match the wire diameter.
S
Incorrect welding parameters
set.
S
Liner worn.
S
Check/replace the contact tip
S
Correct the welding parameters.
S
Replace the wire liner.
Porous welds
S
Large amount of spatter in the
gas nozzle.
S
Insufficient or total lack of
shielding gas.
S
Draught is disturbing the
shielding gas.
S
Clean the gas nozzle.
S
Check contents of the gas
bottle/hoses and the pressure
setting.
S
Shield welding area with
protective screens.
9 DISASSEMBLY AND DISPOSAL
The welding torch system is mainly made from steel, plastics and non-ferrous metal
and must be disposed of in compliance with local environmental regulations.
The disposal of coolant is also subject to local requirements.
Dispose of electronic equipment at the recycling facility!
In observance of European Directive 2002/96/EC on Waste Electrical and Electronic
Equipment and its implementation in accordance with national law, electrical and/or
electronic equipment that has reached the end of its life must be disposed of at a
recycling facility.
As the person responsible for the equipment, it is your responsibility to obtain
information on approved collection stations.
For further information contact the nearest ESAB dealer.
10 ORDERING SPARE PARTS
MXH™ 300PP/400wPP is designed and tested in accordance with the international and
European standards IEC/EN 60974-7 and EN 60974-7. It is the obligation of the service
unit which has carried out the service or repair work to make sure that the product still
conforms to the said standard.
Spare parts may be ordered through your nearest ESAB dealer, see the last page of
this publication.
GB