i-CON 1 / 30
3BA00180 • 8.04.008 • Rev. 1
Operating instructions
6.4.7 Device number
This function is only required, if the i-CON 1 is equipped with a serial PC-interface
(Option). An unambiguous device number must be assigned for identification, to
enable the PC to correctly allocate the connected station.
Please proceed as follows to set the [Unit number]:
■
Open the configuration mode and choose the option [Unit number].
■
Activate the menu [Unit number] by turning the i-OP.
■
Press the i-OP to activate the cursor, press the i-OP again de-acti-
vates the cursor.
■
Enter the desired number from [01] to [3] by turning the i-OP accord-
ingly.
If the cursor is activated, turning the i-OP changes the value of the pa-
rameter accordingly. Details for correct assignment of device numbers
can be found in the documentation for the serial PC-interface.
Each station must have its own number. A double assignment of a
number is not unambiguous and can lead to malfunction.
