i-CON 1 / 15
3BA00180 • 8.04.008 • Rev. 1
Operating instructions
6.2
The Work mode
After the station has been switched on, the switch-on dialog is displayed for approx.
seconds. This dialog shows the station name
a
and the software version
b
of
the i-CON 1. The station will then automatically change to work mode with the pa-
rameters:
• actual value
c
• set value and possibly standby status
d
• connected soldering tool (i-Tool in our example)
e
• password lock active (KEY-symbol)
f
In the work mode, the soldering tip temperature can be directly changed by turning
the i-OP. Confirm this by pushing the i-OP.
If the password lock is activated, the set value can only be changed
via the parameter mode. The password is needed.
6.2.1 Software version
These operating instructions refer to firmware 2.16. For service purposes the
number of the software may be of help, you should therefore make a note of it and
keep it ready, as you may need it when asked by our Service Department.
