Erkodent Erich Kopp GmbH • Siemensstraße 3 • 72285 Pfalzgrafenweiler • Germany
Tel.: +49 (0) 74 45 / 85 01-0 • Fax: / 85 01-15 • www.erkodent.com • [email protected]
Occluform-
3
Occludating device to imprint the opposing bite during thermoforming.
Suitable for the units Erkoform serie 3.
Occluform-3, order number: 188 580
Pre-assembled: model pot and occludating device • Accessories: granules shovel and hex-wrench size 3.
Installation and instructions
press button
occludating bow
arresting joint
supporting pin fixation
model plate
supporting pin
joint column
fixation screw
fixation ring
swing bolt
granules shovel
hex-wrench size 3
model pot
The construction of the Occluform-3 device is based on
a Bonwill triangle with a side length of 11.5 cm (dashed
triangle) and a Balkwill angle of 20°.
Remove device parts and accessories and check for
completeness.
Joint position ex works,
this position is the best
starting position to
articulate the models.
Align marking line of the
fixation ring to the point
at the form pot.
Installation instructions:
Put the fixation ring
crossways onto the
form pot and press it
downwards to the limit
stop (supporting pin to
the right).
Press fixation ring
downwards and tighten
the fixation screw with
the hex-wrench.
Open package and remove supporting cardboards.
!
Release a stiff
arresting joint by
moving it several
times.
Never oil or
lubricate!
Never lubricate
or grease the
articulations!
