Ericsson R250d PRO, Руководство пользователя

Страница: 20 / 65

16 Basic Operations
Turning Your Terminal On and Off
Press and hold
YES
or
NO
until your terminal beeps. The
display and keypad backlighting will come on for about
15 seconds. The display should look similar to this illus-
tration. After your terminal locates the network, your
service provider’s name appears in the first line of the
display. If there is no service provider, then the word
Scanning...
appears in the first line of the display.
Press and hold
NO
until your terminal beeps and the dis-
play goes blank.
Making Calls
Making Calls in Phone Mode
1 Verify that Phone Mode is selected.
2 Enter the phone number you want to call by press-
ing the numeric keys. The number is shown in the
display. Press
CLR
to erase a digit. Press and hold
CLR
to erase all digits.
3 Press
YES
.
Dialing
is shown in the display while
your terminal attempts to access the system. When
your terminal accesses the system,
InUse
is shown
on the bottom line of the display.
Call
replaces
Dialing
, as shown in this illustration.
If the Call Timer is enabled, the duration of the call
(in minutes and seconds) is shown in the display
beside
Call
.
4 When you finish your conversation, press
NO
to end
the call.
Making Calls in Radio Mode
1 Verify that Radio Mode is selected.
2 Enter the phone number you want to call by press-
ing the numeric keys. The number is shown in the
display. Press
CLR
to erase a digit. Press and hold
CLR
to erase all digits.
3 Press
377
.
Dialing
is shown in the display while
your terminal attempts to access the system. When
Basic Operations
Call 00:01