Ericsson EXN401, Руководство пользователя

Страница: 132 / 180

Bridging
3.4.5.4 Bridge Virtual Port Commands
3.4.5.4.1 maxmac
Description This command is used to set the maximum number of
different MAC addresses that the virtual port can support.
Syntax
maxmac maxValue
maxValue
The maximum number of MAC addresses. 0
means no fixed limit.
no maxmac maxValue
Restores default value.
Default 0
Modes Bridge Virtual Port configuration
Example To configure the maximum number of MAC addresses to 10:
EXN400(config-bridge-port)# maxmac 10
3.4.5.4.2 learning
Description This command is used to turn on/off dynamic learning on a
particular virtual port. Learning mode cannot be enabled if the bridge is not
in learning mode. In addition, changing the learning mode at the bridge
level changes the learning mode for any existing virtual port.
Syntax
[
no
]
learning
learning
Learning enabled
no learning
Learning disabled
Default Learning enabled
Modes Bridge configuration, Bridge Virtual Port configuration
Example To disable learning on the virtual port:
EXN400(config-bridge-port)# no learning
3.4.5.4.3 force-forward
Description This command is used to force forwarding of packets from a
virtual port to another one.
For Unicast packets, the forwarding process toward the destination port is
performed whatever the status of this MAC address, i.e. unknown Unicast,
118
1553-LZY 214 2655 C 2004-11-24