EDACS CONVENTIONAL P1 SCAN
This feature permits the radio user to scan a pre-programmed conventional
system and channel as a Priority 1 (P1) channel while the radio is selected
for EDACS trunked system. If activity is detected on the conventional P1
channel, the radio will unmute and remain on this conventional channel for
the programmable hang time.
The radio must be pre-programmed to designate a button for scan on/off op-
eration.
DYNAMIC REGROUP OPERATION
Dynamic regroup operation permits multiple talk groups (up to eight) to be
added to a radio via the system manager. The radio must be pre-programmed
to respond to regrouping. Dynamic regrouping will not be activated in a ra-
dio until an activation message is sent by the system manager. Each radio
that receives and acknowledges a regrouping instructions is successfully re-
grouped.
Pressing and holding the
C
(Scan Model) or
c
(System Model) but-
ton for 2.5 seconds toggles the user into and out of the dynamic regroup
groupset. A double beep will sound for entry or exit. The display will indi-
cate
REGR_0x
where "x" is a digit of 1 to 8 indicating the group when dy-
namic regroup has been enabled by the user. If the radio is in dynamic
regroup and the user selects a group that has not been regrouped, the display
will show
NO ENTRY
. The radio will be prevented from transmitting and
receiving calls in this condition except for scanned groups.
Emergency Operation
If the pre-programmed groupset on the currently selected system contains an
EMER/HOME group and the radio is in dynamic regroup, the radio will exit
dynamic regroup and declare the emergency on the HOME group. If no
EMER/HOME group is present, the radio will declare the emergency on the
currently selected dynamic regroup group.
52