5. Press
< a third time to set the group to Priority 1. A "1" is displayed
on line one. The priority level selection sequence only advances the
group to next higher priority level and stops at priority level 1. To select
a lower priority level, the group must be deleted from the scan list and
then added back to the scan list. Each new group added to the scan list
starts at the lowest priority. If the the Priority 1 and Priority 2 groups are
already set and a new group is assigned as Priority 1 or Priority 2, the
previously assigned group will change to non-priority scanning.
Deleting Groups From A Scan List
1. With scan operation turned off, select the desired group to delete from
the selected trunked system’s group scan list.
2. Press
< or > on the SCAN add/delete control. The current status of
the group is displayed for a time-out period.
3. Press
> to delete the group from the scan list. "S", "2" or "1" turns
off. Any group that is not in a trunked system group scan list will show a
"blank" for the time period when it is the selected channel.
Nuisance Delete
A group can also be deleted from the scan list, if it is not the currently se-
lected group, by pressing
> during scan operation while the radio is dis-
playing the unwanted group. The group will be deleted from the system’s
group scan list in the same manner as if done using the steps above. Dele-
tions done in this manner will not remain deleted if the radio is turned off
and then back on.
Turning Scan On
1. Toggle scan operation by pressing
k
. The SCAN indicator will turn
on when the radio is scanning.
The
k
key light will blink when temporarily disabled.
NOTE
Scanning will stop while microphone is off-hook if hookswitch fea-
ture is enabled through programming.
NOTE
40