Unlicensed LPWA Gateway 5780
1/1553-KRC 161 673 UEN Rev PB9 2017-03-24
Ericsson AB 2017
24 (45)
Commercial in confidence
6.3
Install Support 6501
“For permanently connected equipment, a readily accessible disconnect
device shall be incorporated external to the equipment”.
“The equipment shall be supplied from an external power supply source in
compliance with the clause 2.5 of the standard IEC 60950-
1”.
Steps
To install the Support 6501, do the following:
1. Connect the grounding cable.
This step is not mandatory if the
gateway is already grounded. See
chapter 6.4.
2. Loosen the screws on the installation
hatch on the support 6501, and remove
the installation hatch.
3. Loosen the screw in the strain relief.
4. Remove the protective plug and loosen
the connector screws for the power cable
wires on the socket connector. Insert the
power cable wires and tighten the screws
