Operating instruction
Hydraulic system with Motor drive PXD compact
Document no.: B-00021
Edition 2019 09
Operating instruction EN
Copyright by Ergoswiss AG
17/25
5.5
Setting the shown height on the display
(Only with manual control switch type Memory!)
The displayed height can be adjusted with this feature.
1.
Drive to any desired height and press the button
S
(Save).
Display:
2.
Keep the button
pressed for about 5 seconds, until the display starts flashing.
Example:
3.
Now the button
(plus) or
(minus) can be used to set the current height.
While doing so, the system does not move!
4.
With the correctly set value the new height is saved by pressing
S
(Save).
5.6
Reset of the control box
(Only with manual control switch type Memory!)
5.6.1
Redefine end positions («S 7»)
1.
Press the buttons
1
,
2
and
simultaneously, until «S 5» or «S 7» is displayed.
2.
Press the button
until
«S 7»
appears on the display.
3.
Press the button
S
(Save).
The display is flashing «068»
→
carry out initial operation according to chapter 4.
5.6.2
Reset control box to factory settings («S 0»)
1.
Press the buttons
1
,
2
and
simultaneously, until «S 5» or «S 7» is displayed.
2.
Press the button
until
«S 0»
appears on the display.
3.
Press the button
S
(Save).
The display is flashing «068»
→
carry out initial operation according to chapter 4.
