T
he
M
y
M
ac
K
angaroo
P
ro
-
aSSeMBLy InSTrUcTIonS
Assembly Parts list
A. (2) Black Screw Covers
B. (2) 1/4-20 x 3.50 Hex Head Bolts
C. (1) 5/32 Allen Wrench
D. (2) Fender Washers
E. (2) Acorn Nuts
F. (3) 1/4-20 x 7/8 BHCS
G. (2) Thick Black Washers
H. (1) 7/16 Wrench
I. (2) Locking Star Washers
Step 1:
Lay the lifting assembly on a solid surface with the back side up as shown. Notice the single Button Head
Bolt in the assembly union plate.
DO NOT LOOSEN THE SINGLE BUTTON HEAD BOLT THAT IS NOTATED.
Step 2:
Notice the (2) oversized holes in the Base Plate. The Single Button Head Bolt will go into the oversized hole
on the top right, while the other 3 holes should line up with the base. The center oversized hole is not used with this
unit.
Step 3:
With the Base Plate over hanging the table about 2 inches, hold the Lifting Assembly above the Base Plate
and align the Single Button Bolt into the oversized hole. Place one 1/4-20 x 7/8 BHCS{F} through the base plate to
screw in the lifting assembly.
Step 4:
Insert and thread the other (2) 1/4-20 x 7/8 BHCS{F} through the Base Plate and into the Lifting Assembly.
Once all (3) bolts are threaded in, tighten securely with the 5/32 allen wrench{C}. Lifting Assembly should be flat
against the Base and all three bolts should look like the picture above.
Apple mounting plate and mount
instructions included. Please visit this
youtube link below to view an instructional
video on attaching your apple display to the apple adaptor kit.
www.youtube.com/watch?v=4D5_uMBMaCY
The Apple adaptor kit provides the 100 x100mm hole pattern needed
to attach to the mount on the unit.
Step 1
Step 2
Step 3
Step 4
A
B
C
D
E
F
G
I
H
Threads of Spring
Single button
head screw
Oversized Holes
Lifting assembly
should be flat against
the base plate
when tight
Back Side of
Lifting Assmebly
