Erbauer EAG18-Li, Оригинальное руководство пользователя

Страница: 15 / 19

29 28
3.
Cutting (I)
When cutting, do not press, tilt or oscillate the machine. Work with moderate feed,
adapted to the material being cut.
Do not reduce the speed of running down cutting discs by applying sideward pressure.
The direction in which the cutting is performed is important. The machine must always
work in an up-grinding motion. Therefore, never move the machine in the other direction!
Otherwise, the danger exists of it being pushed uncontrolled out of the cut.
WARNING!
For cutting metal, always work with the wheel guard for
cutting.
WORKING HINTS FOR YOUR ANGLE GRINDER
If your power tool becomes too hot, run no load for 2-3 minutes to cool the motor. Never
start your angle grinder with the disc/ accessory in contact with the workpiece. Always
start at no load to achieve maximum speed then start working.
Do not force the disc to work faster, reducing the disc’s moving speed means longer
working time.
When grinding, always work with a 30° to 40° angle between disc and workpiece. Larger
angles will cut ridges into the workpiece and affect the surface finish. Move the angle
grinder across and back and forth over the workpiece.
When using a cutting disc, never change the cutting angle otherwise you will stall the
disc and angle grinder motor or break the disc.
When cutting, only cut in the opposite direction to the disc rotation. If you cut in the same
direction as the disc rotation the disc may push itself out of the cut slot.
When cutting very hard material best results can be achieved with a diamond disc. When
using a diamond disc it will become very hot. If this happens you will see a full ring of
sparks around the rotating disc. Stop cutting and allow cooling at no load speed for 2-3
minutes.
Always ensure the workpiece is firmly held or clamped to prevent movement.
USE
01 INTENDED USE
The machine is intended for cutting and grinding metal and stone materials without using
water. For cutting, a special safety guard for cutting (accessory) must be used.
02 OPERATION
OPERATING INSTRUCTIONS
• Clamp the workpiece if it does not remain stationary due to its own weight.
• Do not strain the machine so heavily that it comes to a standstill.
• Grinding and cutting wheels become very hot while working; do not touch until
they have cooled.
STARTING OPERATION (G)
To start the power tool, press the rear of the on/off switch (3) and push forwards.
To lock the on/off switch, press the on/off switch down at the front until it engages.
To switch off the power tool, release the on/off switch or, if it is locked, briefly push down
the back of the on/off switch and then release it.
1.
Hand grip areas
Always hold your angle grinder firmly with both hands when operating (H).
2.
Grinding (H)
The best grinding results are achieved when setting the machine at an angle of 15°
to 30°. Move the machine back and forth with moderate pressure. In this manner, the
workpiece will not become too hot, does not discolour and no grooves are formed.
WARNING!
Never use a cutting wheel for grinding.