TO OBTAIN FCC & ISED CERTIFICATION NUMBERS
From the Luxe terminal screen, click on the
Compliance
icon
to display the FCC/IC information (see Compliance screen).
The Compliance screen displays the FCC/IC
certification numbers applicable to the device.
SAFETY INFORMATION
This device must be used within the operating conditions, electrical supply requirements, environmental conditions and connec-
tion requirements as specified below:
Power Supply: These devices must be connected to the correct electrical supply. Connection to an inappropriate supply may
damage or destroy this device(s), thereby invalidating its warranty(s).
Only operate this device within the temperature range of 0 °C - 45 °C.
Hazardous Environments: This device must NOT be installed in locations where there is danger of explosion.
INSTALLATION GUIDE
INSTALLATION GUIDE
LUXE
6200m FAMILY
LUXE
6200m FAMILY
SHIPPING
CONTENTS*
Equinox Payments
9045 E. Pima Center Pkwy, Suite 3, Scottsdale, AZ 85258, USA | Tel: +1.877.497.3726 | Fax: +1.480.551.7811 | www.EquinoxPayments.com
© 2018-19 Brookfield Equinox LLC (DBA Equinox Payments), all rights reserved. Equinox Payments & the Equinox Payments logo
are registered trademarks of Equinox Payments. Information within this guide may not match the terminal device and its
accessories exactly and thus are subject to change. 940663-001E Rev. D 01/19
Luxe 6200m:
Base device
Communication Cable
Power + Ethernet HUB
Power Supply
Power Cable
Installation Guide
940663-001E
9 4 0 6 6 3 - 0 0 1 E
* Contents may not match exactly as shown.
Guide applies to 1 Luxe 6200m configuration: Base
CLEANING DEVICE
WARNING:
Do NOT use industrial strength or an abrasive cleaner as it may damage or scratch the device/screen.
Do NOT immerse device in any liquid.
Do NOT spray water or cleaner into MSR or Smart Card Reader slots or ports.
Apply distilled water or mild cleaner on to a soft, lint free cloth. To clean, gently wipe down the terminal.
WARNING
Only use the provided Equinox Payments A/C Power Adapter.
Non-compliant power adapters may damage the device.
Do not use if visibly damaged.
Do not expose to temperatures below -10 °C or above
60 °C storage (not powered).
Do not disassemble.
Intended operating humidity range is 5% to 95% rh (non-condensing).
This device is not designed or certified to be used in a
flammable atmosphere such as a petrol station or chemical
depot where there is a risk of explosion.
Keep out of reach of children or pets.
Do not incinerate or crush.
NOTICES
If a power supply was NOT shipped with the Luxe terminal or if there is NOT an immediately available power supply to use with
the Luxe terminal, use the following when selecting and using a suitable power supply:
Must use Equinox P/N
870088-001E
• Must use a suitably safety Listed power supply, output
rated 9-12Vdc 2A or greater AND must be a certified Limited Power Source (marked “LPS”).
COMPLIANCE
FCC ID: COL-LUXE6200M
• IC: 2279B-LUXE6200M
•
UL/cUL Listed E249765
This device complies with Part 15 of FCC Rules and Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions:
1) This device may not cause interference, and
2) This device must accept any interference, including interference that may cause undesired operation of the device.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a partic-
ular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
• Increase the separation between the equipment & receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
WARNING:
Changes or modifications to the equipment that are not expressly approved by the responsible party for
compliance could void the user’s authority to operate the equipment.
If trouble is experienced with this device, please contact Equinox Payments at 1.877.497.3726 for repair or warranty infor-
mation. If this device is causing harm to the telephone network, the telephone company may request that you disconnect
