Equinox Systems ISP juno, Руководство пользователя

Страница: 18 / 60

ISPJUNO - Portable ISP Programmer - User Guide V0.84 – 17/04/20 17
2.5 Programmer Status LEDs
The current status of the programmer is displayed on the programmer Status LED’s as detailed in the
table below.
Fig. 2.6.5 Programmer Status LED’s – state descriptions
Status LED
Display
State State Description
WAITING
•
Programmer is now waiting to start an ‘Autoprogram’
operation.
BUSY
•
Programmer is ‘BUSY’ performing a programming
operation.
•
If the programmer is controlled from EDS, the BUSY LED
will remain on after a programming operation until a
‘RESET programmer’ command is executed.
FAIL
•
Programming operation has FAILED.
•
See programmer LCD for diagnostics
•
Programmer will automatically switch off target power if it
is controlling power.
PASS
•
Programming operation was successful.
Status LED key:
Please note:
•
There are also two special modes called ‘Waiting Target Connection’ or ‘Waiting Target
Disconnection’ where the yellow ‘BUSY’ LED will FLASH.
•
These modes are enabled when ‘Target Connection Sense’ is enabled in the Programming
Project.