R01PS
User Manual
Version: V 1.0 November, 2012
The Do
’s and Don’ts
Common Fault Analysis
▲ Do not place the product in high temperature, high humidity, dust, salt spray
or other severe environment. Do not make it exposed in the rain, which may
cause fault.
▲ Do not press the LCD Display, the outdoor device lens or the top black ball,
otherwise it will cause hardware damage. Once the lens or LCD screen is
broken, please be careful scratch yourself, prevent LCD liquid from entering
your eyes.
▲During the installation, please operate it carefully, do not pull the yellow FPC
cable hard to damage it. The damage caused by improper operation is not in
Warranty.
▲ Please use the manufacturer standard charger to ensure normal usage and
system safe.
▲ Please refer to the User Manual when you install battery, Micro SD card, FPC
connection and insert USB cable. Please take care of the direction or polarity to
protect the hardware and system from the improper insertion.
▲ Please do confirm the door thickness and choose the proper screws as per
User Manual to protect the device from the improper screws.
1. If
you can’t drive the screws in place or can’t fix the outdoor
device, it may be due to the screws, please confirm the door
thickness again and choose the proper screws.
2. After pressing the Preview Key, it shows
Device not Ready
,
Failure
, etc., it may be due to the FPC cable not connected with the
monitor properly or destroyed, please connect the FPC cable
again. If it is still inoperative, maybe the FPC cable damaged, need
to change the FPC cable or outdoor device.
3. Under the conditions of Mcro SD card insertion, when you take
photo/video, it show
Please insert Micro SD card
, please reinsert
the card. If it is still inoperative, please change the card.
4. If the monitor LED flashes regularly (approx.1 time per 3
seconds), which alert Low Battery, please charge timely.
5. If the monitor alarms continuously, no display with pressing the
Preview Key, the yellow FPC may not be connected properly or
damaged. Please connect the FPC cable again, if it is still
inoperative, it maybe the FPC cable or connector destroyed.
Installations
1
2
3
4
5
Remove the traditional
peephole viewer or open a
new hole (recommend hole
size approx.20mm)
Tear off the foam of the
adhesive on the back of
the outdoor device.
Choose the right screws
according to the door thickness,
drive 5 circles slightly, then
make the outdoor device go
through the hole.
Ensure the doorbell downward,
fix onto the door with adhesive.
Tidy the FPC cable, make
it go through the rectangle
hole of the steel bracket.
6
7
8
9
10
Drive the screws tightly and
fix the steel bracket, please
notice.
Insert the Micro SD card.
Please notice the front, back
and direction of the card.
Open the battery cover and
fasten the FPC cable. Please
take care of the connection
direction
Install the battery and fasten
the cover. Please take care of
the polarity.
Fasten the monitor with
the steel bracket.
