QX5
QXFXO4/QXISDN4/QXE1T1/QXFXS24; (SW Version 6.0.x)
78
QXFXO4/QXISDN4/QXE1T1/QXFXS24 Manual II: Administrator’s Guide
The
IDS Logs
table is a list of new or read IDS entries and descriptions
referring to them. The table provides a status row that has the value
New
if the entry is still unread or it is empty if the entry has already
been read.
Mark All as Read
marks all IDS logged entries as read and removes
the
New
status from the
Status
row of the IDS entries table.
Delete Log
is used to delete all entries from the IDS table.
A detailed log of the selected entry can be seen by clicking on the
Description
link of the corresponding entry in the
IDS Entries
table.
Fig.II- 103: IDS Log page
The IDS Logs detailed page has a following preview:
The
Issue Detailed Log
table is a detailed list of new and read IDS
entries. The table contains a
Status
row that has the value
New
if the
entry is still unread or that is empty if the entry has already been read.
Fig.II- 104: IDS issue detailed preview
Filtering Rules
The
Filtering Rules
page allows you to configure the filters for incoming and outgoing traffic.
To prevent inaccurate configuration, only one rule per service is allowed. The user may use IP groups to include several IP addresses for this rule. Since
the filtering rules specify the operation mode of the firewall, they only take effect if the firewall has been enabled (additionally NAT should be enabled to
use the
Port Forwarding
function in the
Incoming Traffic/Port Forwarding
filtering rules). The filtering rules are independent from the security level, so
they will work if enabled, no matter what security level has been selected.
Please Note:
Applying firewall rules will prevent the establishment of new connections that violate the rules. Applying rules does not kill existing
connections that violate the rule.
Attention:
The newly created blocking filtering rules will take effect immediately if there is no any active connection matching to that rule. Otherwise, if
there is an active connection matching to the created blocking rule, please restart the QX gateway to make the newly created blocking rule effective
immediately. However, if you are unable to restart the QX gateway, you may need to stop an existing active connection to make the newly created blocking
rule effective. Please note, that in this case the blocking rule will take effect only in 3 minutes.
View All Filtering Rules
View All
displays all configured filters specified by their
State
(enabled or disabled), the selected
Service
, the set
Action
(allowed
or blocked), the IP addresses the filters apply to (if
Restricted
) and
the destination of port forwarding. Since it is read-only, no
modifications are allowed and no functional buttons are available.
Fig.II- 105: Filtering Rules page
