QX5
QXFXO4/QXISDN4/QXE1T1/QXFXS24; (SW Version 6.0.x)
67
QXFXO4/QXISDN4/QXE1T1/QXFXS24 Manual II: Administrator’s Guide
The
Tunnels to Master Devices
page consists of a table where master devices are listed with the corresponding authentication parameters.
Add
functional button leads to the
Add Entry
page where a new master device parameters needs to be provided.
The
Add Entry
page consists of the following components:
The
Enable Registration
checkbox selection is used to enable the
registration to the corresponding master device.
The
Tunnel Name
text field requires the SIP tunnel name for the
corresponding connection. System suggests you to start the SIP
tunnel name with the “SIP_Tunnel_” words, according to the
automatic prefix used for the SIP tunnels on the QX, however this
is not mandatory.
The
User Name
text field requires the authentication user name.
The field in front of this text field displays the default non-editable
prefix for SIP tunnels: “SIPTunnel_”.
The
Password
text field requires the authentication password.
Please Note:
The
User Name
and
Password
should match both
on master and slave QXs for the successful SIP tunnel
establishment.
Fig.II- 81: SIP Tunnel Settings – Tunnels to Master Devices – Add Entry page
The
Master device IP
text field requires the IP address of the master device.
The
Master device port
text field requires the SIP port number of the master device.
The
Registration State
field displays information whether the slave device is registered on the master or not.
The
Registration Date/Time
field displays the time and the date of last registration on the master’s device.
NAT Traversal Settings
The
NAT Traversal
Settings
page is divided into separate pages used to configure General NAT Settings, SIP, RTP and STUN parameters for NAT and a
page where the NAT Exclusion table may be filled.
General Settings
The
General Settings
page consists of a manipulation radio
buttons group to select the mode of the NAT Traversal usage for
the SIP traffic (any incoming and outgoing SIP messages from and
to the QX will be routed through the NAT router).
•
Automatic
– with this selection, system will analyze the QX’s
WAN IP address and if it is in the IP range specified for local
networks (according to RFC), the SIP traffic will be routed
through NAT. Otherwise, if QX’s WAN IP address is outside
the specified IP range, no SIP traffic will be routed through
NAT router.
•
Force
– with this selection, all the SIP traffic will be routed
through the NAT router.
•
Disable
– with this selection, no SIP traffic will be routed
through the NAT router.
Fig.II- 82: General NAT traversal Settings page
SIP Parameters
The
SIP Parameters
page is used to configure NAT specific settings for SIP and offers two independent groups of settings:
