Quadro4Li Manual II: Administrator's Guide
Administrator’s Menus
Quadro4Li; (SW Version 5.3.x)
78
To Delete an IP Range from the NAT Exclusion Table
1.
Select the checkboxes of the corresponding IP range(s) that should to be deleted from the
NAT Exclusion Table
. Press
Select all
if all IP
ranges should to be deleted.
2.
Press the
Delete
button on the
NAT Exclusion Table
page.
3.
Confirm the deletion by pressing
Yes
. The IP range will then be deleted. To abort the deletion and keep the IP range in the list, press
No
.
Line Settings
The
Line Settings
are used to configure Quadro IP Line (if available on the board) settings. The
Line Settings
page consists of
IP Line Settings
page for IP Lines configuration.
IP Line Settings
The
IP Line Settings
page is used to configure IP lines for IP phones to be connected to the Quadro. Quadro provides the options to connect SIP
phones to its LAN side, assign the corresponding IP line to an active extension, and use SIP phones as a simple phone with all telephony services of
the Quadro (for example, call hold, waiting, transfer, etc).
There are 16 IP lines available on Quadro4Li.
The
IP Lines Settings
page displays a table with the available IP lines on the Quadro.
Enable PnP to IP lines
checkbox is used to setup the SIP phones connected to the Quadro via Plug and Play automatic configuration service. To
use this service, this checkbox needs to be selected. The SIP phone should be reset then. After a clean boot-up of the SIP phone, Quadro will detect
the SIP phone and all its characteristics, generate the automatic configuration file and will upload it to the SIP phone. The SIP phone will be then
configured on the first available IP line of the Quadro and will become completely functional.
Please Note:
The Plug and Play service is only available for the supported SIP phones (see the list below). This service will not work in case the SIP
phone is already manually configured or if it is not reset after enabling the
Enable PnP to IP lines
checkbox.
Enable Firmware Version Control
checkbox is used to control the firmware version running on the SIP Phone attached to the Quadro. This service
also allows you to have the new firmware automatically downloaded and installed on your SIP Phone (in case your SIP phone was running an old
firmware upon connecting to the Quadro or when the Quadro’s firmware has been updated and the compatibility was changed to the higher firmware
version of the SIP phone). Every new firmware of Quadro is compatible to a certain firmware version of each supported SIP phone. If you are running
older firmware on your SIP phone, this service will automatically download and install the newer firmware on your SIP phone.
Please Note:
The Firmware Version Control service is only available for the supported SIP phones (see the list below).
Attention:
Do not select this checkbox if you wish to run other firmware version on your SIP phone than the one compatible with the Quadro.
The
Connect IP phones from WAN side
checkbox indicates whether the IP phones are connected to the Quadro via its WAN or LAN port. Disable
the checkbox if the phones are placed on the Quadro LAN; otherwise leave it enabled.
The alternating
Hide disabled IP lines
and
Show disabled IP lines
buttons are used to respectively hide or show the IP lines that have not been
activated with a feature key. To enable the lines, install a feature key from the
page.
The
IP Lines
table lists all available IP lines with additional information about each of them: number of the extension attached to it, information about
the phone type and the configuration details.
Each column heading in the tables is link. By clicking on the column heading, the table will be sorted by the selected column. When sorting
(ascending or descending), arrows will be displayed next to the column heading.
By pressing on the
IP line #
link in the
Available IP Lines
column
,
the
Edit IP Line
page specific for the current IP line is opened. This page offers a
group of manipulation radio buttons that allows you to enable the IP line and to configure it to for use by the SIP phones.
