Quadro4Li Manual II: Administrator's Guide
Administrator’s Menus
Quadro4Li; (SW Version 5.3.x)
28
SMS Settings
The
SMS Settings
are used to configure the SMS parameters
that will allow Quadro to send the voice mail notifications or
event notifications via SMS to the extension user’s mobile
phone. Every extension user can enable voice mail notifications
when a new voice mail is received and they can to define their
own mobile numbers from the Voice Mail Settings or to set the
certain
notification to be delivered per SMS. However,
for Quadro to deliver SMS notifications, the SMS service should
be enabled and SMS settings should be configured from this
page.
Enable SMS Service
enables the SMS service on the Quadro.
User Name
and
Password
text fields require the authentication
settings of the SMS server.
SMS Sender Address
requires the source address for the
Quadro notification SMS. The address defined in this field will
be seen in the “From” field of the SMS delivered to the mobile
phone.
SMS Recipient Address
requires a destination mobile number
for a test SMS.
SMS Gateway
manipulation radio buttons allow to selected
between pre-defined Clickatell SMS gateway and the custom
defined SMS gateways.
Fig. II-46: SMS Settings page
•
Clickatell
– this selection allows to use a pre-defined SMS gateway. Selection enables the
API ID
text field which indicates a Clicatell specific
parameter obtained from the server and should match on both sides.
•
Custom
– this selection allows to use a custom SMS gateway. Selection requires following parameters to be inserted:
Resource
text field requires the HTTP resource name on the SMS gateway, for example: /http/sms.cgi.
Parameters
text field requires the parameters to be submitted to the resource address. The value of this field represents a string with
tokens (separated by percent (%) symbols) inside. Each token indicates a value of the certain field on this page. The value is dependent
on the SMS gateway requirements. For example:
user=%username%&password=%password%&to=%to%&from=%from%&text=%text%
The tokens are the strings that have the following dependencies from the field in this page:
%username% – indicates the username defined in the field
Username
%password% – indicates the password defined in the field
Password
%to% - indicates the password defined in the field
SMS Recipient Address
%from% - indicates the password defined in the field
SMS Sender Address
%text% - indicates the SMS text generated by Quadro (voice mail notification, event notification, etc.)
Server
text field requires the IP address or the host name of the SMS gateway.
Port
text field requires the port number of the SMS gateway.
Use Secure HTTP
checkbox enables access to SMS server via HTTPS. Checkbox selection enables a
Secure Port
text field that
requires the port number for HTTPS traffic.
Request Method
manipulation radio buttons allow to select the HTTP request method used by Quadro the access the SMS gateway:
POST
or
GET
.
Send Test SMS
is used to send a test SMS to the defined SMS Recipient Address. This button will be enabled if correct values have been
submitted and saved on this page.
Firmware Update
This window allows updating the software of Quadro by installing new firmware (image). Users registered at Epygi will receive a notice when new
firmware is available and will be able to download it from the Epygi Technical Support WEB page.
Updating new firmware requires a working power supply. Quadro is provided with a battery (accumulator). If the battery is low or simply absent the
“There is no battery or voltage is low” warning is displayed.
