QuadroFXO Manual II: Administrator's Guide
Administrator's Menus
QuadroFXO (SW Version 3.0.x)
25
Diagnostics
The
System Diagnostic
page gives a possibility to run Network
and WAN protocol diagnostics, to verify Quadro's connectivity and
to download all system logs for possible problems recovery.
The
Start Detecting WAN Protocol
button is used to initiate
WAN diagnostics that will detect the WAN IP configuration: static
or through DHCP and PPP servers. For static WAN IP
configuration, gateway availability is checked. When acting as a
client, DHCP and PPP servers' accessibilities are being verified.
The
Start Network Diagnostics
button is used to initiate network
diagnostics, i.e., to check the WAN link and IP configuration, to
verify gateway, DNS primary and secondary (if configured)
servers' accessibilities.
The field below will display the diagnostics results and the
connectivity conditions. The system should be reconfigured if
problems occur during the diagnostics.
The
Download system logs
button is used to download all logs
to the local PC as a *.tar archive file. These logs can then be used
by the Epygi Technical Support Office to determine the problem
that had occurred on your Quadro.
The
Reboot this Device
button is used to reboot the Quadro.
Please note that the session with the Quadro will be closed, i.e.,
the Quadro GUI should be newly opened and a new login will be
required afterward.
Fig. II-37: System Diagnostic page
Upload Language Pack
Upload Language Pack
page allows to upload a custom language
for GUI and Voice Messages of the Quadro. The language of voice
messages can be switched to the custom Language Pack
language from GUI setting page at the
. The language of GUI session can be changed to the
custom Language Pack language from the radio buttons on the
login page.
Uploading a Language Pack will cause the loss of the following
data:
•
All internally stored voice mail
•
DHCP leases
•
Call statistics
•
Pending events
•
Transfer statistics
Please Note:
Only one custom Language Pack can be uploaded
at the time. Uploading a Language Pack will remove the existing
one (if existing) and will reboot the Quadro.
Fig. II-38: Upload Language Pack page
Current Language Pack
field displays a read only information about the custom language pack uploaded. When no custom language pack is
uploaded, field indicates “unknown”.
Below, there is a
Language Pack File to Upload
text field which displays the selected image filename.
Browse
button is used to browse the custom
language pack to be uploaded.
Remove Current Language Pack
link is seen only when custom language pack is uploaded and is used to remove it from the system.
Pressing
Save
will start uploading the custom language pack to the board. The next page will be displayed, showing the result of a verification of the
language pack being uploaded and asks for confirmation to overwrite the existing custom language pack (if any).
After final confirmation, system will upload the selected custom Language Pack and will reboot.
