QuadroFXO Manual II: Administrator's Guide
Administrator's Menus
QuadroFXO (SW Version 3.0.x)
22
Mail Settings
The
System Mail Settings
page gives a possibility to send warnings automatically about the board status or problems to the administrator.
System
events that require email notification are selected on the
page. Besides, system mail has to be enabled and the SMTP server needs to be
configured for voice message transmission to the extension user’s mailing account.
Enable
enables the system mail sending possibility and voice
messages transmission to the extension user’s mailbox.
SMTP Host
requires the SMTP host IP address or domain
name. The SMTP host needs to be configured to enable voice
message transmission.
Mail Sender Address
requires the source address for the
Quadro notification emails. The email address defined here
should be an existing valid email address registered on the
selected SMTP server or should have permission to use that
particular SMTP server for emails transmission.
Mail Recipient Address
requires an active email address. The
e-mail recipient here can be a Quadro administrator or someone
responsible for network and system problems.
Enable SMTP Authentication
has to be selected if the
specified SMTP server requires an authentication. In this case,
authentication
User Name
and
Password
configured on the
SMTP server should be defined in the corresponding text fields.
Send Test Mail
is used to initiate a test e-mail transmission.
This button will be enabled if correct values have been
submitted and saved on this page.
Fig. II-32: System Mail Settings page
To configure the System Mail
1.
Enable the system mail sending by the
Enable
checkbox selection.
2.
Update or set the SMTP host in the
SMTP Host
text field.
3.
Update or set the e-mail sender address in the
Mail Sender Address
text field.
4.
Update or set the e-mail address in the
Mail Recipient Address
text field.
5.
Enable
SMTP Authentication
if it is required of the server.
6.
Insert into the corresponding text fields an authentication
User Name
and a
User Password
defined by your SMTP server.
7.
Press
the
Save
button to submit these settings.
8.
Use
the
Send Test Mail
button to send a test e-mail with the configured settings.
