Epson TM-P80, Техническое справочное руководство

Страница: 74 / 154

74
Software Setting Mode
I n t he sof t ware se tting mode, yo u ca n se t t he follow ing c u s t om i zed val u es a n d memory sw it ches
wh i ch are sof t ware sw it ches of t h i s pr int er.
Starting the memory switch setting mode
Follow t he s t eps below t o r un t h i s mode.
1
Install the roll paper.
2
Close the roll paper cover.
3
While pressing the Feed button, turn the power on. (Keep pressing the
button until the printer starts printing.)
The pr int er s t ar t s pr inting t he c u rre nt s t a tu s of t he pr int er.
Whe n t he pr int er f ini shes pr inting t he pr int er s t a tu s, t he follow ing messa g e i s pr int ed a n d
t he POWER LED flashes. (The pr int er i s n ow in t he self- t es t wa it mode.):
“Selec t Modes by press ing Feed b utt o n .
Co ntinu e SELF-TEST: Less t ha n 1 seco n d
Mode Selec ti o n : 1 seco n d or more”
4
Press the Feed button. (Keep pressing the button until the printer starts printing.)
The pr int er s t ar t s pr inting in s t r u c ti o n s.
5
After the printing has been completed, press the Feed button 2 times.
6
Press the Feed button again. (Keep pressing the button until the printer
starts printing.)
The pr int er s t ar t s pr inting in s t r u c ti o n s. Follow t hem.
Af t er o n e se tting has bee n comple t ed, t he pr int er s t ores t he se tting a n d t he n s t ar t s initi al i z ing .
Af t er t ha t , t he pr int er re tu r n s t o t he n ormal mode.

Print density

Automatic paper reduction

Interface mode

USB class

Print speed

NV graphics memory capacity

Command execution during offline

Transmission of status notice

Buzzer Settings

Automatic power off time

Paper position immediately after the specific
state

Column emulation settings
For detailed information about customized values and memory switches, see "Software
Settings" on page 46 .