Epson Stylus Pro 9000 - Print Engine, Руководство по обслуживанию, Страница: 50 / 198

EPSON Stylus Pro 9000
Troubleshooting 50
NO INK OUTPUT FROM ONE OR BOTH PRINTHEADS
If there is no ink output from one or both printheads, try each of these steps in
succession until the problem is resolved:
1. Make sure the ink valve on the outer side of each I/H assembly is open.
(The small arrow should point to “OPEN.”) Then perform an initial ink
charge as described in
Cleaning menu on page 128. Run a test print and
check for output.
2. There may be a problem with the ink valve or tubing. To test, place a
syringe on the end of one of the dampers (see
Figure 4-27 on page 73).
Try to draw ink through it. If ink cannot be drawn through the damper, the
ink valves may be defective or the ink tubing blocked. Service these parts
as needed.
3. The Capping Assembly may be damaged or clogged. Remove the
Capping Assembly and rinse it in cold water. Inspect the edges of the
rubber seal. If damaged, replace the Capping Assembly.
Place a syringe on the tubing leading from the bottom of the Capping
Assembly and try to draw water through it. If water cannot be pulled
through, replace the Capping Assembly.
4. Reinstall the Capping Assembly, Pump Mechanism, and tubing in the
printer. Make sure the tubing from the Capping Assembly isn’t pinched or
crimped. Then move the carriage to home position.
Place a syringe on the end of the tubing that leads to the Flushing Box
(Right). Slowly (to avoid damaging the printhead) try to draw ink through
the tubing. If ink cannot be drawn through the tubing, there is a problem
with the seal between the Capping Assembly and the printhead.
5. The Pump Mechanism may be defective. Turn the printer on and perform
the capping position adjustment. See
Cap Position Adjustment on
page 116. Turn the printer off, turn it back on, and then run a cleaning
cycle as described in
Cleaning menu on page 128. While the cleaning
cycle is running, watch the end of the tubing leading to the Flushing Box
(Right). If ink does not flow through the tubing, replace the Pump
Mechanism.
If these steps do not restore printhead operation, the problem is probably not
mechanical. Check the electrical connections between the Main Board and the
printheads. Check that the Main Board is producing printhead driving signals
and that the signals are reaching the printheads. Replace the Main Board or
printheads as needed.
UNEVEN PRINTING OR POOR RESOLUTION
If printout quality suffers from unevenness, poor quality, or similar problems,
check the following:
1. Perform the Head Gap and Bi-D Adjustments
See
Head LR Adjustment (Head Gap Timing) on page 123 and Bi-D
Adjustment on page 121.
2. If the printing problem occurs only when the user prints on thick paper,
press the SelecType button until the “Paper Configuration” menu appears
and set the correct paper thickness. (Depending on the paper-thickness
setting, the location where the ink strikes the paper may change.) See
Paper Configuration Menu on page 16.
3. If the printout quality still has not improved, perform the following
adjustments in the order listed below:
B Head Slant/C Head Slant Adjustment (Head Angle) on page 119
BC Head Slant Adjustment (Head Height) on page 120
Head LR Adjustment (Head Gap Timing)
on page 123
Bi-D Adjustment on page 121
C A U T I O N
Even if you performed the Head Gap and Bi-D
Adjustments in step 1, you must perform them again
after doing the Head Angle and Head Height
Adjustments in step 3.