214
The Control Panel
This operation changes according to the Auto Cut settings.
Note:
This setting is available for roll paper only.
INTERFACE
You can select an interface to receive your print data. When you
select
AUTO
, the printer automatically switches between interfaces,
depending on which one is receiving data first. When you select
USB
,
IEEE1394
, or
OPTIONAL I/F CARD
, only the selected interface
receives your print data. If no more print job is received, the
printer returns to an idle state after 10 seconds or more.
CODE PAGE
You can select a code page:
PC437
(extended graphics) or
PC850
(multilingual).
Paper Source
Print Page Line
Printer’s Operation
Roll Auto Cut On
On
Prints a page line on the right
side only, and cuts paper
automatically after the print
job.
Roll Auto Cut On
Off
Does not print any page lines,
and cuts paper automatically
after the print job.
Roll Auto Cut Off
On
Prints page lines on the right
side and below the data, but
does not cut paper
automatically after the print
job.
Roll Auto Cut Off
Off
Does not print any page lines
and does not cut paper.
Содержание Stylus Pro 7400
Страница 1: ...English User s Guide ...
Страница 258: ...258 Paper Handling The roles of switches and meanings of the Sensor light are as follows Auto Switch Manual Switch ...
Страница 284: ...284 Paper Handling If the paper thickness is 0 5 mm or more feed the paper forward ...
Страница 376: ...376 Options and Consumable Products Note The product number varies by country ...