Epson Stylus Pro 7400, Руководство по обслуживанию

Страница: 48 / 428

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Product Description Control Panel 48
†
Paper Suction
The suction power to attract paper can be adjusted when the Paper Set Lever is
released, and when a paper is detected by the Rear Manual Feed sensor and the PE
sensor. The suction level is indicated by an icon as shown below.
1.4.3 Job Information
†
Job Definition
Each print job is defined as a “Job”* and the printer stores a variety of information
on each job as job history. The following flowchart shows the storing procedure
inside the printer.
NOTE: As cleaning can be executed during printing, it is not defined as a job.
Figure 1-9. Storing Job Information
Table 1-34. Paper Suction Icon
Suction Power
Icon
High 168%
Middle 60%
Low 0%
C H E C K
P O I N T
When rewinding roll paper to align its top edge with the guide line,
setting the suction power to its maximum makes the work easier
and accurately.
Printing
The job is canceled The job finished normally
Count Start
JS
Count End
JE (Cancel)
Count End
JE (Cancel)
Stores the job information
Stores the job information
Ready status