Epson Stylus Pro 7400, Руководство по обслуживанию

Страница: 313 / 428

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Adjustment Basic Adjustment 313
5.3 Basic Adjustment
5.3.1 RTC&USB ID&IEEE1394 ID
This allows you to write date and time to be maintained by the RTC, USB ID and
IEEE1394 ID to the newly mounted Main Board.
†
Procedure
1. After replacing the Main Board, write down the 10-digit ID (IEEE1394 ID)
on the ID label affixed on the right frame of the printer.
2. Turn the printer ON.
3. Start up the Adjustment Program and select [RTC&USB ID&IEEE1394 ID].
4. Check if the date and time displayed on the screen is correct. Enter the date
and time if necessary.
5. Enter the 10-digit serial number of the printer. USB ID is automatically
created according to the serial number.
6. Enter the 10-digit IEEE1394 ID written down in Step 1 into the box.
7. Click the [Write] button to write the information entered into the boxes onto
the NVRAM on the new Main Board.
8. Click the [Next] button to display a confirmation screen. All the information
written on the NVRAM is displayed on the screen. Confirm the information
and click [OK].
9. Click the [Finish] button.
Figure 5-22. IEEE 1394 ID Label
Figure 5-23. [RTC&USB ID&IEEE1394 ID] Screen
C A U T I O N
If the printer is turned OFF and back ON after changing the USB
ID, the computer (Windows) detects the USB port used to connect
the printer as a new port and automatically copies the printer
driver as xxxx (copy x). If you need to perform another adjustment
using the Adjustment Program, exit out of the program and select
the “copy x” driver, then restart the program.
IEEE 1394 ID Label