Epson Stylus Pro 7400, Руководство по обслуживанию

Страница: 287 / 428

EPSON Stylus Pro 7400/7800/9400/9800 Revision B
Disassembly & Assembly Disassembly Procedure 287
4.2.7.5 CLEANER, HEAD, A, ASP
1. Remove the PUMP CAP ASSY. See Section 4.2.7.4 on page 284.
2. Release the CLEANER, HEAD, A, ASP from the two hooked tabs, and remove it
from the PUMP CAP ASSY.
Figure 4-141. Removing the CLEANER, HEAD, A, ASP
C A U T I O N
Never touch the CLEANER, HEAD, A, ASP with bare hands as the
oil of your hand remained on the cleaner surface may repel ink and
cause partial dot omission. Use a pair of tweezers cleaned by a
cleaner or etc. to handle the CLEANER, HEAD, A, ASP.
Make sure to install the CLEANER, HEAD, A, ASP in the correct
orientation as shown in the figure below.
Figure 4-140. Orientation of the CLEANER, HEAD, A, ASP
A D J U S T M E N T
R E Q U I R E D
Whenever the CLEANER, HEAD, A, ASP is replaced, the
corresponding adjustment must be carried out.
See Chapter 5 on
page 292.
To the Carriage home
direction
Opposite to the home
direction
CLEANER, HEAD, A, ASP
Hooked tabs