Epson Stylus Photo RX520 Series, Руководство по эксплуатации

Страница: 17 / 32

Making Prints From Slides or Negatives 17
En
g
lis
h
Placing 35-mm Slides in the
Holder
1. Fit the holder’s tabs into the two small holes at the
rear edge of the document table.
Make sure the cutouts for 35-mm slides are in the
upper-left corner of the document table (not at the
rear edge) to align them with the transparency
unit window when you close the cover.
2. Place your slides in the film holder as shown and
make sure there is no gap between the slides and
the document table.
Note:
❏
The photos should be the right way up when viewed from
overhead. (The shinier side faces up; the duller side faces
down.)
❏
Make sure you do not press too hard on the document table.
❏
Make sure there is no gap between the holder and the
document table, otherwise the photos may not be clear.
3. Close the document cover completely.
Continue with the steps on page 18 to scan and print
your photos.
Placing 35-mm Film Strips in
the Holder
1. Open the film strip cover.
2. Slide your negative or positive film strip into the
holder, under the tabs.
Note:
The photos should be the right way up when viewed from
overhead. (The shinier side faces up; the duller side faces
down.)
3. Close the film strip cover.
4. Fit the holder’s tabs into the two small holes at the
left edge of the document table.
Make sure the film strip is in the middle of the
document table (not at the rear edge) to align it
with the transparency unit window when you
close the cover.
c
Caution:
Make sure you do not press too hard on the document table.
Cutouts for slides
are in upper-left
corner of
document table
transparency unit window
Bottom
TOP
TOP
Bottom
Film strip is in middle
of document table
transparency unit window