39
Using Roll Paper
❏
Do not select A4 or 100
×
150 mm sheet paper for the Paper Size
setting when roll paper is loaded in the sheet feeder. Doing so causes
unnecessary paper to be fed after each print job. If you have already
started printing, press the
Cancel
button. Wait until the printer
stops printing and feeding paper. Cut off the paper at the back of the
printer, then turn off the printer. The remaining paper is ejected.
Printing area and margins
You can change the printing area and the margins for roll paper
with the printer driver settings. There are two margin settings.
One setting creates a 3 mm margin on both sides of your printout.
The other setting prints with no margins on either side of your
printout.
Follow the steps below to change the margins between pages of
printed data.
1. Select Roll Paper as the Paper Source in the printer driver.
2. When printing is finished, press the
z
roll paper button once
to print a cutting guideline about 14 mm from the bottom of
the print data.
3. To print the next print job, press the
z
roll paper button to
feed the paper back to the printing position. Then start the
next print job. The space between pages is automatically set
to 54 mm, as shown below.
Standard margins
No margins
