After you clean the print head, turn off the printer; then hold
down the
Alt
button as you turn the printer back on. This
prints a demonstration page so you can see if your print quality
has improved. (After the page prints, the
Pause
light comes
on; turn off the printer to exit demonstration mode.)
It can sometimes take up to five cleaning cycles to improve
print quality. If the print quality does not improve after you
clean the print heads five times (printing a demonstration page
to check after each cycle), contact your dealer or authorized
EPSON servicer.
To clean the other print head, replace the one currently
installed (as described below). Then repeat the steps in this
section.
Replacing the Print Head Unit
When you need to switch between color and monochrome
printing, follow the instructions in this section to remove one
print head unit and replace it with the other.
c
Caution:
When you switch between print heads, always leave the ink
cartridges installed in the print head unit. Once you remove
an ink cartridge from its print head unit, it becomes unusable.
1. Make sure the printer is turned on and press the
Pause
button. The
Pause
light comes on.
R
Hudson User’s Guide
A5 size
Chapter 3
10-28-95
DR, pass 2-Rev1
Maintenance
3-3
