Lift the cartridge out of the printer and dispose of it properly.
Do not take the the used cartridge apart or try to refill it.
does get on your hands, wash them thoroughly with
soap and water. ink gets into your eyes,
them
immediately with water.
Turn to page
and follow the steps there to install the new
cartridge.
Note:
When you replace the cartridge, the printer will not recharge the
delivery system again. However, the print head may start moving as
the printer performs normal maintenance procedures. This can take
up to seconds to complete.
Cleaning the Print Head
If print quality diminishes, use the printer’s built-in print-head
cleaning cycle to ensure that the nozzles are delivering ink
properly. To avoid wasting ink, clean the print head only if
print quality declines.
Follow these steps:
Make sure the printer is turned on and the
Pause
light is on.
If the
Pause light is
not on, press the
Pause
button to
pause the printer.
Hold down the
button
press the
Pause
button for
two seconds. The cleaning cycle takes about seconds.
The
Pause
light flashes throughout the cycle and then
stays on when the cleaning cycle is finished.
Press the
Pa use
button to resume printing.
Maintenance and Troubleshooting 3-3
