Epson SQ-2000, Руководство по эксплуатации

Страница: 66 / 181

ton. This special cleaning also takes about two minutes.
Be careful not to unplug the printer too quickly. As with the
other extended cleaning cycle, there’s a quiet period during
which solvent is allowed to soak into the print head and other
parts.
Wait for the POWER light to go out. That’s your signal the
printer is ready to be stored or transported.
Summary of Cleaning Cycles
Here’s a brief summary of the cleaning cycles:
l
The printer automatically cleans itself when it is turned on
and periodically during operation.
l
If you notice a slight deterioration in print quality, push the
ON LINE button to make the printer go off-line. Then press
the CLEANING button for a few moments. To resume print-
ing, press the ON LINE button again.
l
For a more extensive cleaning, wait for the printing to stop,
then turn the printer off. Turn it back on again while pressing
the CLEANING button.
l
When the printer won’t be used for an extended period, or is
to be stored or transported, clear the printing parts of ink by
turning the printer off while holding down the CLEANING
button. Let the POWER indicator go out before unplugging
the printer.
Troubleshooting Guide
The SQ-2000 is often able to tell when something goes wrong,
such as when paper has jammed or someone forgot to replace the
ink cartridge. It does that through special sensing devices.
When such a problem occurs, you may be alerted by a warning
light or buzzer. Or the printer just won’t operate.
The following troubleshooting guide provides some of the
more common problems that may arise during normal operation.
To save time (and perhaps some embarrassment), be sure to refer
to it before you call in service personnel.
46